Installation Instructions

ManualsBrandsHoggan ManualsCloset DoorsTivoli 36" x 80" Oak Folding Closet Door

SINGLE DOOR INSTALLATION INSTRUCTIONS

1 x Top Track

9x Upper sliders

6 x Screws

1 x Upper slider T-style

1 x Folding Door

10x Flat

Head Screws

1 x Female/male connector

2 x Handle pins

2 x Handles

1 x Lubricant tube

1 x Magnetic plate

Before installation begins:

To install a door easily, read the instructions carefully before beginning. So that you can enjoy the use of this door for many years without

any problem, take your time for a correct installatio

Tools Needed

You will need a Philips screwdriver #1 ,measuring tape, a pencil, a 3/32 drill bit in order to drill the holes, a hand saw in case you need to

cut the Top Track (width) or the panels (to adjust the height).The panels must be cut by the bottom part.

FOLDING DOOR

Summary of content (4 pages)

PAGE 1
FOLDING DOOR SINGLE DOOR INSTALLATION INSTRUCTIONS Before installation begins: To install a door easily, read the instructions carefully before beginning. So that you can enjoy the use of this door for many years without any problem, take your time for a correct installation. Tools Needed You will need a Philips screwdriver #1 ,measuring tape, a pencil, a 3/32 drill bit in order to drill the holes, a hand saw in case you need to cut the Top Track (width) or the panels (to adjust the height).
PAGE 2
Section 1 SECTION 1 1. Measure the door opening If the height of the door opening is the same as the measurement of the door, it won’t be necessary to cut the door height, if the opening is less; the door (A) should be reduced by cutting off the excess in the bottom part of the door panels. Place and attach the door panels together, use adhesive tape if necessary and cut off the excess with a saw or handsaw.
PAGE 3
Section 1 E B B 5. Door installation (A) Ensure that all the sliders all well attached, apply the lubricant (E) in the Top Track, then install the door (A) introducing the sliders in the Top Track (B). A B G 7. Fix the anchorage panel Slide the door toward the side of the closing; locate the holes of the anchor panel, mark, punch (if necessary) and screw, fixing the anchor panel. K F G 6. Ensure the Top Track (B) Return the track to its original position.
PAGE 4
Section 2 DOUBLE DOOR SECTION 1 INSTALLATION INSTRUCTIONS 1. Measure the door opening Divide in two parts the measurement of the doorframe width, and then cut the top tracks based on those measurements. This way they will be properly installed and will join together towards the center B B A 2. Install one of the Top Tracks Install one of the Top Tracks, and secure it completely. 3.