User Manual
PRODUCT FEATURES
1-10V LED dimmer is a standard 1-10V passive dimming controller without power supply for controlling various
dimmable LED drivers and dimmable electronic ballasts with 0/1-10V dimming signal to realize LED lamps. The
dimming range is 5-100%, the minimum brightness can be preset and the switch can be turned off.
TECHNICAL SPECIFICATIONS
• Maximum switching load power: 110V 1000W, 220V 2000W
• High current switch: 10A for reliable shutdown (complete turn off)
• Effective dimming signal current: ≤50mA
• Adjust voltage: 0.5-10V
• Dimming range: 5-100% stepless dimming, no stroboscopic
• Minimum brightness preset range: 5%-50%
• 100% compatible with drivers with standard 0/1-10V dimming signal on the market
• Standard EU type panel, size 84x84mm
INSTRUCTIONS
NOTE:
Connect the load and signal rst, then connect the AC input line. Make sure there is no short circuit between the
connection lines before powering on.
1. L IN is the hot line input
2. L OUT is the live line output, connected to the input L end of the 0/1-10V dimming LED driver
3. Dimming signal input, D+ is the dimming signal positive, D- is the dimming signal negative.
IMPORTANT SAFETY DETAILS
1. Hazardous voltage may be present at the output of the dimmer despite setting the dimmer to zero brightness
level. Look out and tag the input circuit before accessing the wiring connections. Failure to follow this warning can
result in death or serious injury.
2. Ensure the AC/Mains power is NOT connected and cannot be unexpectedly reconnected during installation.
3. This product must be installed by a qualied electrician in accordance with instructions provided and in
compliance with recognised electrical and safety regulations relevant to the country it is being installed.
4. This product may NOT be installed by minors or people with a mental disability.
EN