User's Manual

Vectron User manual
© Höft & Wessel AG

Subject to amendment, errors excepted HW8660UserMan.doc 1.0 02.02.2001 Lin
page 42
/
70
6.4 Test printout
To process a test printout:
1. Switch on printer with on/off-key.
2. Open casing flap.
3. Press on/off-key and continue pressing it .
4. Close casing flap.
5. Release on/off-key.
A test printout with an extract of supported fonts und printable charactes will be printed. Also informations
about serial number and BIOS- and bootloader number will be given.
6.5 Printer malfunction
Malfunction Elimination
Printout is not ejected poperly. Check, if paper reel has just been inserted. If so,
take reel out and insert again.
The HW 90195 stops during printing and shows no
more reaction.
The accu block is almost completely discharged
and HW 90196 stopped printing. Recharge accu
block or insert a recharged accu block.
Printing does not start. Read messages in display of terminal.
No message about end of paper reel, printing can
be continued.
Open flap of paper reel casing. Clean sensor for
„paper end“ by blowing out printing unit.
All recieved but not yet printed characters are de-
leted after interruption of connection, resp. connec-
tion establishing, by the radio terminal because of
impossible feedback to radio terminal without radio
connection.
After establishing a new connection the printout can
be repeated.