User's Manual

User manual Vectron
   
© Höft & Wessel AG
page 29/70
Lin 02.02.2001 1.00 HW8660UserMan.doc Subject to amendment, errors excepted
5.6 Connection to a PC
The HW 90196 is able to communicate with a PC via the infrared-system interface or the integrated radio
module.
A communcation station HW 50196 is employed for communication via the infrared-system interface. It
can be connected directly with a PC (H&W-cable 63) or contact can be established via a modem connec-
tion. The modem can alternatively to cable 63 be connected to the communication station.
The connection between HW 90196 and PC (display 400) is established starting from the operating sys-
tem (display 304, „load program“?).
400
load program
via modem ?
No Yes
F4 (Yes)  405
F1 (No)  420
If the connection has once been established, it is possible to send or recieve data. This process is moni-
tored and controlled by the PC.The HW 90196 operates in the server mode, i.e. it reacts only to com-
mands of the PC and the F2 (End)-key.
The connection to the PC is only terminated by a command of the PC, by pressing the F2(End)-key on
the HW 90196 or because of a time-out, if it was not possible to establish the connection or if the connec-
tion hab been interrupted.
405
Phone-Nr./Receiver: ↙
↙↙
↙ (Entry)  410 (Blank entry; MDE switches to call-off
mode)
F2 (End)  300 (system menu)
Entry of a phone number terminated by
↙
↙↙
↙ (Entry)  410 (call MDE)
410
dial up... F2 (End)  450 (Warm start)
after 60 s time-out  450 ( - “ -)
Connect established  415
415
PC-connection
PDE is waiting
F2 (End)
or controlled by the PC  450
Cancel by time-out  450