User's Manual

Vectron User manual



Subject to amendment, errors excepted HW8660UserMan.doc 1.0 02.02.2001 Lin

page 28

Standard settings

Resets radio module to standard settings.

Sent commands Display Possible error messages Remarks

SPBD115200

SPTM PT

SPPR OFF

SPCTR OFF

SPCCN 1

SPINI 0 Setting of standard

settings successful!

Setting of standard settings

failed!

Firmware:

Displays of radio module firmware. The user test menu contains DECT in a submenu with the function

„firmware“ and a notice about the version number and the manufacturer date of the radio module firm-

ware.

Download:

Download of the radio modules with new firmware, the files root.pp and root.bin have to be generated on

the Flash-disk beforehand.

This function does not refer to the mobile printer HW 90195.

5.5.3 Printer

- HW 90196 - Enter the code "30141590" from the basic state of the operating system.

DECT menu

->Printer menu

END

Select „Printer menu“ with arrrow keys.

Enter (↵) for confirmation.

->DECT serial no

Offline Sub. SK

Oflline Sub SMK

Air Subscription

Defaults

Firmware

END

Menu levels DECT-menu Printer

Select with arrow keys and enter (↵) for confirmation.

The DECT-menu for the printer is, concerning its functions, equal to the

one for the HW 90196. The DECT-menu for the terminal additionally con-

tains the menu level „download“.

To configure the radio module in the printer the terminal and the printer have to be aligned with their infra-

red interfaces on the bottom sides of the devices towards each other. The printer must be in IR mode

(see also chapt. 6.6). Stray light influences, e.g. by fluorescent lamps, should be avoided, if possible.