User Manual

EN
8
®
Sport Cub S
Installing the Flight Battery
Your Sport Cub RTF transmitter comes pre-bound to the aircraft, so
binding should not be necessary.
Keep the aircraft and transmitter away from large metal objects, wireless
sources or other transmitters while installing the battery.
CAUTION: Always disconnect the Li-Po fl ight battery from the
aircraft receiver when not fl ying to avoid over-discharging the battery.
Batteries discharged to a voltage lower than the lowest approved voltage
may become damaged, resulting in loss of performance and potential
fi re when batteries are charged.
CAUTION: Always keep hands away from the propeller. When
armed, the motor will turn the propeller in response to any throttle
movement.
5
Sec.
Place aircraft on its
landing gear.
Keep immobile and
out of the wind for
5 seconds.
For best fl ight
performance,
install the
battery all the
way back as
shown.
1.
2.
For a list of compatible DSM2/DSMX transmitters,
please visit www.bindnfl y.com.
CAUTION: When using a Futaba
®
transmitter with a Spektrum DSM module, you
must reverse the throttle channel and rebind.
Refer to your Spektrum module manual for
binding and failsafe instructions. Refer to your
Futaba transmitter manual for instructions on
reversing the throttle channel.
Binding Procedure
1. Refer to your transmitter’s unique instructions
for binding to a receiver.
2. Make sure the fl ight battery is disconnected
from the aircraft.
3. Ensure the transmitter is powered OFF.
4. Connect the fl ight battery to the aircraft and
turn the aircraft upright. The receiver LED will
begin to fl ash (typically after 5 seconds).
5. Make sure the transmitter controls are at
neutral and the throttle is in the low position.
6. Put your transmitter into bind mode.
7. After 5 to 10 seconds, the receiver status LED
will become solid, indicating that the receiver
is bound to the transmitter. If the LED does not
turn solid, refer to the Troubleshooting Guide
at the end of the manual.
8. Disconnect the fl ight battery and power the
transmitter off.
For subsequent fl ights, power ON the transmitter
for 5 seconds before connecting the fl ight battery.
Binding