User Manual

View from Rear
Moves Up
Step 5
9
Tail Control Test (continued)
Step 5
8
Tail Control Test
1. Make sure slide throttle is “off” and then
turn on transmitter.
2. Install and plug in the flight battery.
3. Move the stick side to side while observing
that the tail flaps are moving as shown.
4. Move the stick up and down while observing
that the tail flaps are moving as shown.
5. The small levers under and to the side of
the stick are the trim levers and are used
to adjust the “neutral” point of your con-
trol stick. These should be centered prior
to performing the test.
6. If you find that each flap is not level with
the rest of the tail surface when the trim
levers are centered, adjust the control sur-
faces so they are level. To do this, loosen
the round spool on the control surface.
Then, move the control surface back to
neutral and re-tighten the spool. (See
page 32 for more details).
WARNING: Keep everything clear of the
propeller when you conduct the tail con-
trol test in the event that you acciden-
tally turn on the motor.
Moves Up
Moves Up
Moves Down
Elevator
Trim
Rudder Trim
Right Rudder
Left Rudder
Down Elevator
Up Elevator