User Manual

EN
9
RTF
Beforeeachyingsession,andespeciallywitha
newmodel,youshouldperformarangecheck.
TheDXeincorporatesarangetestingsystem.
PlacingthetransmitterinRANGECHECKmode
reducestheoutputpower,allowingarangecheck.
1. Poweronthetransmitterfor5secondsor
morewiththethrottlestickandtrimlow.
PowerontheESCSwitchandkeeptheaircraft
immobileforatleast5seconds.
2. Facethemodelwiththetransmitterinyour
normalyingposition.ToggletheHI/LOrate
swtich4times.Immediatelypressandhold
the trainer button. TheLEDswillashandthe
alarmwillsound.Thesystemisinrangecheck
mode.
IMPORTANT:Youmustholdthetrainerswitchdur-
ingtheentirerangecheckprocess.Releasingthe
switchwillexittherangecheckmode.
3. Withthesystempoweredonandthemodel
restrainedontheground*,stand28meters(90
feet)awayfromthemodel.
4. Move the transmitter rudder, elevator, aileron
and throttle controls to ensure they operate
smoothlyat28meters(90feet).
5. Ifcontrolissuesexist,donotattempttoy.
Refer to the contact table at the end of the this
manualtocontactHorizonHobbyproductsup-
port.Also,seetheSpektrumwebsiteformore
information.
*Insomeaircraft,whenthemodelisplacedonthe
ground,theantenna(s)canbewithininchesofthe
ground.Closeproximityoftheantenna(s)tothe
ground can reduce the effectiveness of the range
check.Ifyouexperienceissuesduringtherange
check,restrainthemodelonanon-conductive
stand or table up to 2ft (60cm) above the ground,
thenrangecheckthesystemagain.
28meters(90feet)
CAUTION: WhileholdingtheaircraftduringtheRangeTest,always
keepbodypartsandlooseitemsawayfromthepropeller.Failureto
do so could cause personal injury.
Range Check
Mode 2 Mode 1
1 3
2 4
Keep immobile and
out of the wind for
5 seconds