User Manual

EN
5
RTF
KEY
A
Antenna
J
Hi/Lo(DualRate)Switch
B
Trainer/Bind/PanicButton
K
RightControlStick
C
(CH5)SAFEFlightMode
L
Trimbutton(forUp-downonstick)
D
PowerONLED
M
Trimbutton(forLeft-rightonstick)
E
LeftControlStick
N
ThrottleCut
F
Trimbutton(forUp-downonstick)
O
Handle
G
Trimbutton(forLeft-rightonstick)
P
TrainerPort
H
PowerSwitch(ON/OFF)
Q
BatteryCover
I
NeckStrapMount
TheincludedRTFtransmittershouldbeboundtotheaircraft
atthefactory,butifyouneedtore-bind,followthebinding
procedureasshown.
Youneedto‘bind’yourchosenSpektrum
™
DSM2
®
/DSMX
®
technol-
ogy equipped aircraft transmitter to the receiver for proper opera-
tion.Pleaserefertotheoptionalpartslistinthismanualorvisit
www.bindny.comforalistofcompatibletransmitters.

Binding Procedure Reference Table
1. Makesurethetransmitteris
poweredoff.
BIND PLUG
2. Makesurethetransmitter
controls are neutral, the
throttle and throttle trim are
inthelowposition,andthe
aircraft is immobile.
3. Installbindpluginthereceiver
bind port.
4. Connecttheightbatteryin
theaircraft.ThereceiverLED
willbegintoash.
5. Pressandholdthetrainer
button on the top of the
transmitterwhileturningon
thepowerswitch.
6. When the receiver binds to the
transmitter, the light on the
receiverwillturnsolid.The
motorwillarmwiththrottle
andthrottletrimatthelowest
position.
7. Remove the bind plug from
the receiver.
8. Disconnecttheightbattery
fromtheaircraft,thenpower
off the transmitter.
The receiver should retain the binding
instructions received from the transmit-
ter until another binding is done.
Mode 2 Mode 1
Pressandholdthetrainerbuttononthetopofthe
transmitterwhileturningonthepowerswitch.
*Thethrottlewillnotarmifthetransmitter’sthrottlecontrolisnotputatthelowestposition.Ifyouencounterproblems,followthe
bindinginstructionsandrefertothetransmittertroubleshootingguideforotherinstructions.Ifneeded,contacttheappropriateHorizon
ProductSupportofce.
Transmitter Binding