Instructions for use

ENGLISHfraN
ç
aISDEUTSCH
6
even if this car is a ready to run kit, you still have some little things to do to familiari ze with your
product.
please follow these steps.
WARNING!Do not use the
charger if wire is frayed or
worn. Do not use the charger
nearwater or worm.
Connect the AC charger to
a wall 220V plug, the green
LED brights. Then connect the
battery, the LED becomes red:
battery is charging.
After a charging time of 2
hours,the battery will be
charged. (red LED becomes
green).
Steering Wheel : Control direction (Left / Right) of the
RC model
Throttle Trigger : Control speed and direction (Forward/
Brake/Backward) of the driving model.
Antenna : Transmit signal to the model
Power ON / OFF : Power ON / OFF the transmitter
SYNC & Battery Indicator : Top Green LED light indicates
synchronization status and/or
adequate battery power supply.
Power Indicator : LED light indicates power “ON”.
ATV : Adjustable Steering Rate by ATV dial
ST. Trim Dial : Adjust the neutral position of steering
servo when model wheels are straight
ahead.
TH. Trim Dial : Make sure the model stays still when
releasing the throttle trigger.
Battery Compartment Tray : Cover and hold the batteries powering
the transmitter.
Put the battery in its mount.
KT2S TRANSMITTER FUNCTIONS
CHARGING THE LI-ION bATTERY INSTALL bATTERY ON CAR
Battery
Compartment Tray
Steering
Trim Dial
Steering
Wheel
Throttle
Trigger
Throttle
Trim Dial
Bind /
Setup Key
Antenna
Power
Indicator
A
TV
Power
ON / OFF
Throttle
Reverse Switch
Steering
Reverse Switch
bATTERY INSTALLATION
Supplied with 4 x 1.5V AA Batteries,
KT2S can be operated a few hours.
Installation: ❶ Remove the battery
compartment cover as shown
below.
❷ Install the batteries
observing the polarity
marked on battery
compartment.
❸ Then reinstall the battery
compartment cover as the
Picture shown below.
CAUTION :
Do not dispose of batteries in fire,
short their terminals, apply heat to
them or disassemble them. .
Used batteries: Please dispose of
used batteries properly, following
any local regulations.
Battery distributors are required by
law to take back spent batteries;
they must not be thrown away as
household waste.