User Manual

3
Program example with transmitter
Setting “Timing Mode”to “High”, i.e. value #3 in program item #2
1 Enter Program mode
Push the throttle stick to the top position, switch on the transmitter, connect battery to the ESC; wait for 2
seconds, beeb- beeb- will be emitted, then wait for another 6 seconds, special tone ♪ i 3 i 3 will be
heard, that means program mode is entered.
2 Select Programmable Items
There are 6 different tones in loop, when you hear beeb- beeb- ( 2 short tone ),push the throttle stick to the
bottom position within 2 seconds, the “Timing Mode”is selected.
3 Set Item Value ( Programmable Value )
There are 3 tones match to 3 item value. When you hear beeb- beeb- beeb- (3 short tone),push the throttle
stick to the top position within 2 seconds, special tones ♪ 5 6 5 6 will be heard, that means “Timing
Mode”is set as “High” and saved.
4 Exit Program Mode
After hearing special tones ♪ 5 6 5 6 , push the throttle stick to the bottom within 2 seconds, you will exit
program mode.
Configurable parameter with LED program card
Item Specification Option or Value Default
1.Cut Off Voltage
Low Voltage Protection
Threshold
00.0V 49.9V
00.0V
2.StartPower Percent
Start Power Percent
00% 29%
00%(automatic)
3.Advance Timing
Timing Mode (1)Low (2)Mid (3)High (4)Highest Mid
4.Brake Type
Brake Mode
(1)Off (2)Soft (3)Hard
Off
5.Start Mode
Start Mode
(1)Fast (2)Soft (3)Very Soft
Fast
6.Cut Off Type
Low Voltage Protection Mode
(1)Reduce Power (2)Cut Off
Reduce Power
7.Throttle Curve*
Throttle Curve
(1)Curve1 (2)Curve2 (3)Curve3
Curve1
8.Motor Rotation*
Motor Rotation
(1) Forward (2) Reverse
Forward
Notes * these items are invalid in 3A ESC
Wiring Program Card Diagram
+
-
A B C
3A ESC
BLDC
MOTOR
-
+
PROGRAM
CARD
ONE CELL
LI-XX