User Manual

2
Configurable parameter with transmitter
1 BrakeType: Off,Soft brake and Hard brake. default is Off (brake disable). Soft brake: less forceful and brake
time is longer. Hard brake: more forceful and brake time is shorter.
2 Advance Timing: Low, Middle and High, default is Middle. Low advance timing is recommended for high
inductance and low KV motors. High advance timing is recommended for low inductance and high KV
motors, e.g. high KV outrunner motors. For some high KV motors, if it shakes while rotating in high speed,
the “High” timing mode is recommended.
3 Start Mode: Fast, Soft and Very Soft. default is Very Soft. Fast start is recommended for low inductance and
low start loading motors, Very Soft start is recommended for high inductance and high start loading motors.
4 Cut Off Type (Low Voltage Protection Mode): Reduce power and Cutoff output power for selecting, default
is Reduce the output power gradually to 50% of the current power.
5 Cutoff Threshold: 2.8V, 3.0V, 3.1V. default is 2.8V.
Program ESC with transmitter
1. Switch on transmitter ,move
throttle stick to top
position,,connect the battery pack
to ESC
2. Wait for 2 seconds ,the motor
should emit “beeb-beeb-”tone
3. Wait for another 6 seconds ,special
tone like “♪ i3i3” should be
emitted ,which means program
mode is entered
1.Enter program mode
After entering program mode ,you will hear 6 tones in a loop in the
following sequence. If you move the throttle stick to bottom within 2
seconds after one kind of tone, this item will be selected.
beeb- (1 short tone) Brake
beeb- beeb- (2 short tone) Timing
beeb- beeb- beeb- (3 short tone) Startup mode
beeb- beeb- beeb- beeb- (4 short tone) Cutoff mode
beeb- beeb- beeb- beeb- beeb-
(5 short tone ) Cutoff threshold
beeb----- beeb-----” (2 long tone) Exit
2.Select programmable items
There are two ways to
exit program mode:
1. In step 2, after 2 long
tone (The item #6)
please move throttle
stick to the bottom
position within 2
seconds.
2. In step 3,after special
tone
♪ 5 6 5 6 , please
move throttle stick to
the bottom position
within 2 seconds.
4.Exit program
After entering the item, you will hear several tones in loop, Set the value
matching to a tone by moving throttle stick to top within 2 second when you hear
the tone, then you will hear special tone like ♪ 5 6 5 6”. It means the value is set
and saved.
Wait for 3 second, you will go back to step 2, if push the throttle stick to the
bottom position within 2 second, you will exit the program mode quickly.
Tone
Items
beeb-
1 tone
beeb-beeb-
2 tone
beeb-beeb-beeb-
3 tone
1.Brake Off Soft brake Hard brake
2.Timing Low Mid High
3.Start Mode Fast Soft Very Soft
4.Cutoff Mode Reduce power Shut down
5.Cutoff threshold Low(2.8V) Mid(3.0V) High(3.1V)
3.Set item value