User Manual

Per verificare lo stato:
Accendere l'ESC e ascoltare i "Beep" e la note emesse:
• "Beep--" + "SI-LA-SOL" o "SOL-LA-SI"
Stato: Registra Punto Neutro + Protezione OFF
• "Beep - Beep--" + "SI-LA-SOL" o "SOL-LA-SI"
Stato: Registra Punto Neutro + Protezione ON
Per programmare:
A ESC spento premere e tenere premuto il "program switch", accendere l'ESC, e
rilasciarlo in base ai "Bip" emessi per programmare:
• "Beep--": entrambe le protezioni sono OFF.
• "Beep - Beep--": entrambe le protezioni sono ON.
Stato predefinito: OFF
- Impostazione della modalità di funzionamento
Per verificare lo stato:
Accendere ESC e verificare la luce LED e i "Bip" emessi:
• "Bip--" o "Bip - Bip--" + "SI-LA-SO--" o "SO-LA-SI--" + LED lampeggiante
Stato: modalità NORMAL
• Motor "Bip--" o "Bip - Bip--" + "SI-LA-SO--" o "SO-LA-SI--" + LED luce fissa
Stato: DRAG BRAKE
Per programmare:
1) Accendere l'ESC.
2) Tenere premuto "Interruttore di programmazione" per 2 secondi per cambiare
modalità, rilasciare per programmare in base al "Bip" emessi:
• "Beep--": modalità NORMAL.
• "Beep - Beep--": modalità DRAG BRAKE.
Stato predefinito: NORMAL.
2