User Manual

Turn the TX on. The sensor’s LED will blink just one second (the fastest response
in the world at the present time). It can be saved as “zero movement” for
reference.
During this time; the module stores the “zero movement” reference. It’s very
important NOT to move the sensor at that moment, as any little measurement
error will cumulate over time and create drift.
After few seconds, move your X-GYRO and your camera should be moving
synchronized with X-GYRO.
Although the system is designed by our excellent engineer, almost no motionless
drift for the system, but it can also generate minor drift by long time and
repeated movement.
That head movement cannot match up the position of the camera, you can simply
look straight and press the button shortly, and the system will rememorize central
position and correct its output signal instantly to secure movement synchronism.
The processing is so short that you make no influence during flying.
The temperature change may cause the center moving.
If the center has deviation, just short press the button to re-center X-GYOR
X-GYRO Programming：
The configuration menu is entered at power-up, when power is applied, the LED
will blink with high brightness and it indicates entering menu options, following
high brightness blinks comes with continuous and interval low brightness blinks, it
indicates the present menu options, you can select your desired option in turn
from them continuously and periodically by a short button press.
A long press(>2 second) will store it and the next setting then appears, the same
setting interface can be repeated and periodical, if you want to finish the present
settings, you can just shut off the power and then turn on it again.