User Manual

The purchase of a trainer connector module is necessary to active the function.
Once the appropriate module is installed in the transmitter, the X-GYRO is
equipped with a 3.5mm stereo JACK connector may be used.
These connectors don’t supply power, you need to connect an external power for
it. The simplest way is to use a 9V battery, since the current drawn by the X-GYRO
is low enough that a single battery should last a long time, of course, it will be
economical if you use a 7.4V high capacity Li-Po battery.
Multiplex transmitter:
High-end Multiplex transmitter series (Royal Evo, Cockpit SX, mc4000) can also
compatible with X-GYRO. The different with Graupner is Multiplex Tx can supply
power to X-GYRO without external power. You need right connecter for Multiplex,
please read user’s manual to know the detail specifications about transmitter
setting.
JR and other transmitters without programmable channel:
Some JR transmitters can support selective merging trainer channel, some of
them can’t, but it is so pity it appears that only the first 4 channels are supported
(the JR 9303, 9X is one example of this). So users can only use X-GYRO on those
simple 2-3 channel models with JR transmitter.
Radio Setting:
If your transmitter can program their channel setting and also can program
student’s channel setting while turn on trainer function, you don’t need to change
the setting the X-GYRO. If your transmitter can’t change the student’s channel
setting, you can use the programming function of X-GYRO. More detail about X-
GYRO setting, please read the section “X-GYRO Porgramming”.