User Manual

Compatible Transmitters
Futaba:
The X-GYRO is compatible with high end FUTABA transmitters FF-7, FF-8, FF-9,
T9Z, T12MZ, T14MZ, supporting trainer/student function by using 6 pins square
trainer connector.
Some of these transmitters can supply power directly to X-GYRO, no need
external power, but some transmitters using need external power for X-GYRO.
The external power wire has included in package.
The X-GYRO can generate standard PPM signal and send it through your radio to
receiver. (The default channel: channel 7 and channel 8, it’s programmable.) Your
transmitter need support trainer function and channels need to be
programmable.
The system can send standard PPM signal to those unused channels. Since the
FUTABA transmitters especially the FF9/9C series, trainer switch is spring
Switch, only if you leave it always “on” can realize its function. The simplest way
for it is to hold the switch on with a rubber band.
Other high-end transmitters such as (T9Z, T14MZ) have already put the trainer
channel to always “on” channel.
Other notice is the trainer function of some models of Futaba need to reset after
you change model.
Graupner:
High-end Graupner transmitters can be used with X-GYRO(MC20, MC24, MX22),
and they are actually support selective trainer channel merging.
You can also check the manual of the transmitter and get the procedure
correspondingly, but these expensive transmitters didn’t take the trainer
connector as a standard feature.