User Manual

Entering setting mode:
Please press the re-center button continuously, then connect with the power and
wait for 5 seconds, so you can enter setting mode, the sensor’s LED will blink for
reminding the entering setting mode afterwards.
You can see two signal lights blinking with different brightness.
The times of high brightness blinks indicates serial numbers of menu and the
times of continuous low brightness blinks indicate option numbers on menu.
Option 1:
Options for X axis (pan axis) working channel---one high brightness blink.
1. One blink of low brightness indicates Channel 1
2. Tow blinks of low brightness indicate channel 2
3. Three blinks of low brightness indicate channel 3
4. Four blinks of low brightness indicate channel 4
5. Five blinks of low brightness indicate channel 5
6. Six blinks of low brightness indicate channel 6
7. Seven blinks of low brightness indicate channel 7
8. Eight blinks of low brightness indicate channel 8
Option 2:
Options for Y axis (tilt axis) working channel, two blinks of high brightness, it is
same as the above, please select the channels that are different with X axis.
1. One blink of low brightness indicates Channel 1.
2. Tow blinks of low brightness indicate channel 2.
3. Three blinks of low brightness indicate channel 3.
4. Four blinks of low brightness indicate channel 4.
5. Five blinks of low brightness indicate channel 5.
6. Six blinks of low brightness indicate channel 6.
7. Seven blinks of low brightness indicate channel 7.
8. Eight blinks of low brightness indicate channel 8.