User Manual

35
Forexample,ifWINDBOXtobesetastraineecontroller,thetraining
functionshouldbedisabled.Whiletheoutputmodeshouldbe
changedtoPPMsignaloutput. 
1. In“TrainerSetting”menu,select“OFF”foroption1; 
2. Open“OutputMode”menu; 
Setthevalueofoption1from“Built-in2.4G”to“futabaPPM”,
thenconnectWINDBOXwithcoachTransmitterviatrainercable.
4.19 Connectwith433/915MRangeExtender
 WINDBOXcanworkwith433/915Mrangeextendertoincrease
remotecontroldistance.TheWINDBOXwilloutputPPMsignalstoa
433Mtransmittermodule,andtherewillbea433Mbpsreceiveron
theaircraft.

Settingwithcable: 
1. Connecting:Onesideofthesimulatorcableshouldbeconnected
tothePPMinputportofthe433Mrangeextender; 
2. Theothersideofthesimulatorcableshouldbeconnectedtothe
PPMoutputportofWINDBOX;
3. Open“OutputMode”menuoftheWINDBOX; 
4. Select“futabaPPM”foroption2. 
