User Manual

19
2. Open“OutputMode”menu; 
3. Option1:select“Built-in2.4G”;
4. Option5:select“12CH-FHSS”;
5. Option6:regeneratetheuniqueIDofcontrollerforavoiding
interferencebetweencontrollersinaction;
6. Option2:select“MatchCodeOn”;
7. Turnonthereceiver  ;
8. Indicatorlightofthereceiverquicklyflashedfor10timesandturned
off. 
9. Option2:select“ModeCodeOff”’
10. Re-electrifythereceiver.Ifthereceiverisconnected,theindicator
lightofthereceiverwillkeepon;otherwise,theindicatorlightwillbe
turnedoff.Incaseofthelatersituation,repeatabovesettingsteps.

4.8 SwitchbetweenPPMandPWMModeofthe
Receiver
●Thereceivercanworkunderfollowingtwomodes:
1.PWMmode:PWMsignaloutputfromtheNo.1toNo.12portinthe
frontofthereceiver,andSBUSsignaloutputfromtheSBUSport.