Winch servo
IRSA Supported 65 Class Rules August 2018 9
PART 2 – REQUIREMENTS AND LIMITATIONS
The competitor and the boat shall comply with the rules in Part 2 when racing.
Certification control to check compliance with rules of Section C is not part of
certification.
Certification control shall be carried out in accordance with the current ERS
except where varied in Part 2.
Equipment Inspection is used to check compliance with the rules of Section C.
Section C – Conditions for Racing
C.1 GENERAL
C.1.1 RULES
The rules of Section B of the ERS shall not apply.
C.2 COMPETITOR
C.2.1 Limitations
(a) One competitor only shall control the boat.
(b) The competitor shall not be substituted during an event.
C.3 ADVERTISING
C.3.1 LIMITATIONS
The boat may display only such advertising as permitted by the WS
Advertising Code.
C.4 HULL
C.4.1 LIMITATIONS
The geometry of the hull shell shall not be changed during an event.
C.4.2 DIMENSIONS
(a) Maximum hull length in relation to the datum waterplane is
661 mm. See Figure J.1.
(b) Minimum hull length in relation to the datum waterplane is
649 mm. See Figure J.1.