Winch servo
IRSA Supported 65 Class Rules August 2018 13
have:
(1) voids in the waterplane;
(2) voids in the profile below the datum waterplane;
(3) hollows in the plan view that exceed 3 mm;
(4) hollows in the profile under the datum waterplane that
exceed 3 mm;
(5) transverse hollows in the undersurface of the hull that
exceed 3 mm when tested parallel to the waterplane as
in Figure J.3.
D.2.4 FITTINGS
Fittings shall not project outboard of the hull.
Section E – Hull Appendages
E.1 GENERAL
E.1.1 RULES
Hull appendages shall comply with the current class rules.
E.2 HULL APPENDAGES
E.2.1 MATERIALS
Materials of higher density than lead (11,340 kg/m
3
) are prohibited.
Section F – Rig
F.1 PARTS
F.1.1 A rig shall have no more than one mast.
F.1.2 The following are prohibited:
spar section fairings, spar section extensions, or articulated flaps.
F.2 GENERAL
F.2.1 RULES