Winch servo
IRSA Supported 65 Class Rules August 2018 10
C.5 HULL APPENDAGES
C.5.1 LIMITATIONS
The same hull appendages shall be used during an event except when
a hull appendage has been lost or damaged beyond repair.
Replacement may be made only with the approval of the race
committee who shall then remove or cancel any event limitation mark
attached to the replaced hull appendage.
C.5.2 DEPTH RESTRICTION
The depth restriction gauge, when oriented transversely as in Figure J.2,
shall be capable of being passed under the
hull appendages
without
either of the two upper corners of the gauge losing contact with the
hull
.
C.5.3 USE
The hull appendages:
(a) containing or forming ballast shall not be rotated relative to the
hull;
(b) shall be attached to the hull at the centreplane;
(c) shall not project fore or aft of the hull in relation to the datum
waterplane as found in Figure J.1; and
(d) shall not be shifted, articulated, retracted, or extended.
C.6 RIG
C.6.1 LIMITATIONS
(a) Not more than three rigs shall be used during an event.
(b) Spars lost or damaged beyond repair may be replaced only with
the approval of the race committee who shall then remove or
cancel any event limitation mark attached to the replaced
item.
C.6.2 USE
The rig shall not project fore or aft of the hull in relation to the datum
waterplane as found in Figure J.1.
C.6.3 DIMENSIONS
(a) The deck limit mark to the top point dimension, ignoring any