User Manual

14 / 14
Calibrate will be finish in about 30 seconds
Reset Default Setting

Choose Reset Default in the menu and press the OK key, it will restore the factory settings

After restoring factory settings, depending on the connection mode, please configure the
serial data type and baud rate once again , do IMU self test and IMU calibrate if using the
built-in AHRS modules
View AHRS Data

Menu select View AHRS data and confirm , the IMU self test and calibrate values will be
display in OLED panel
OSD ON/OFF

Select OSD ON/OFF and confirm in the menu, to switch the OSD enable or disable
Warning:

Because the interface wiring much more , so please again to make sure wiring is correct,
incorrect connection may cause damage
Packing list:

OSD Transmitter*1

Cable set*1

Antenna*1