User Manual

10 / 14

Using the remote control 3-band switch or joysticks can toggle the OSD panel interface

PPM<1.2ms is OSD off

PPM>1.8ms is OSD panel 2

other PPM>1.3ms and PPM<1.7ms is OSD panel 1
Mode 1: using the built-in 10 axis AHRS

Click OK，select Com Setting in the menu，select GPS in list Com Type，click OK to save
setting ，click ◀ back

This mode is the easiest to use mode, users only need connect to the battery power, video,
audio, GND wire, without having to connect other devices, built-in AHRS provides attitude
message, for example: pitch angle, roll angle, heading direction, barometer etc.

This mode , geographic and distance(home distance) with no data
Mode 2: using the built-in 10 axis AHRS + GPS

Click OK，select Com Setting in the menu，select GPS in list Com Type，click OK to save
setting ，click ◀ back

Click OK，select GPS Band rate in the menu , select the baud-rate for GPS in list , typical
GPS baud rate is 4800 or 9600 and 19200

This mode is mode 1 for additional，need connect to GPS module

Will be complete show all profile information, as well as the whole function of longitude,
latitude and distance display