User Manual
[4]
δΈƒ. Mode setting: (Note: all the setting can be used normally after restart, also, the setting model can be exit after restart.)s
Brake(BR1)
LED Flashes
Hold Set Switch
Brake(BR1)
LED Flashes
Brake(BR1)
LED Flashes
Brake(BR1)
LED Flashes
Brake(BR1)
LED Flashes
Ch1 (LR)
Ch4 (ROF)
Ch4 (FR2)
Ch4 (AUX2)
Ch2 (Brake)
Normal Off
Night Mode
Low Power
Low Power
Low Power
Normal ON
Day Mode
Mid Power High Power
Mid Power High Power Buzzer
Mid Power High Power
ON OFF ON OFF ON OFFManual Hazard
Save and Back to [Channels Menu]
Auto Hazard start time
Ch4 Polarity
Flash Rate
Default Toggle Step
Ch2 Polarity
Turns/Hazard flash rate
Mid
Slow
Slow Mid
Reverse
2
3 4
Fast
Very Slow
Very Slow
Normal
Normal
1
Fast
Save and Back to [Timing & Other Menu]
Press SET 1s
Battery Type
Low Voltage
Detection
Channels
Menu
Timing And
Other Menu
Default Setting
SET 1s
SET 1s
SET 1s
Press SET
Press SET
Fast
Slow
OFF
Mid
LiPo 2S LiPo 3S LiFe Po 4S LiFe Po 3S
Battery
Type
Low Mid High (max.12.6V)
Low Voltage
Detection
Flashing time of the brake light
Default setting
Ch3
Reverse
SET 1s
SET 1s
SET 1s
SET 1s
SET 1s
SET 1s
SET 1s
SET 1s
SET 1s
Saved and back to setup loop
Always bright, reset
to default setting
then restart
SET 1s
SET 1s
SET 1s
SET 1s
SET 1s
SET 1s
Turn on ESC(connect the power), keep
holding SET switch for 3s, until the light
turn off.