User Manual

四. Product installation:
Please make sure the polarity of the connector is correct before installation or it will damage the lighting sets.
Lamp-socket instruction:
L: Turn left light AUX1: front light (small) FR2: head light2 Fr1: head light1 R: right turn light
Br1: brake light AUX2: back light (small) FOG: fog light ROF: top light REV: backing-up light
五. Channel input and LED function
Start to use:
1. connect all input channels which you
need before power on ESC
2. power on ESC, the BR1 of the LED
system will flash for around 10 sec
(Ch1 CH2 will AUTO-CALIBRATE),
and then please keep all the channels
in NEUTRAL position until to the Br1
stop flashing. All the functions of this
LED system will run normally when you
operate it according to the above step.
LED
system
LED
L
AUX2
FR2
FR1
R
REV
AUX1
ROF
FOG
BR1
LED
SETBATT
Main cable
CH3CH4 CH2 CH1
Servo
Battery cable
Receiver
ESC
Not for power supply, but
low voltage detection only.
Battery
LiPo/LiFe/NiMH
1-6 cells
Channel input
Channel 1
Channel 2
Channel 3
Channel 4
Function Output Details
Turn signal
L 、R Left and right turn light
Throttle BR1 、REV Brake light will 100% lighting when braking, otherwise it will keep in the setting state
Back-up light
When TH stop to use about 10 senconds,(it will show Auto Hazard state)
[2]
For the switch,
need to set up
when operate
Manual operation
change function
FR1、FR2
ROF
FOG
L 、R
Head light 1、Head light 2
Top light
Fog light
Operate Auto Hazard by manual
BR1\ROF\AUX1\AUX2
FR1、FR2
FOG
Keep the lights bright cyclic by manual to meet the requirement of the lights
when movement