User Manual

2, On-Screen-Display In-Flight Interface Screen

When the system is connected and powered up. The On-Screen-Display(OSD) in-ﬂight

interface screen should be as shown in Figure 2.1. The functions of the display contents

will be described in the following of this chapter.

2.1 General Information

2.1.1 Timer

The timer can be used for measure the duration of the ﬂight. There are two activation

mode of this timer. By setting in the PC conﬁguration software, it can be selected between

the “Power-On Start”, which the timer will be started when the OSD is powered up, and the

“Take-Off Start”, which the timer will be started when take-off of the plane is detected by

the system. The instruction of the PC conﬁguration software will be described in the

chapter 3 and 4.

2.1.2 Time

The time will be shown on the top-right of the screen once the GPS is locked. The default

time zone is “0” (UTC time). You may set your respective time zone accordingly in the

OSD conﬁguration menu or via PC conﬁguration software. The instruction of the OSD

conﬁguration menu and PC conﬁguration software will be described in the chapter 3 and 4.

2.1.3 Date

The date will be shown on the top right of the screen once the GPS is locked according to

the set time zone.

AEO TECHNOLOGY www.aeorc.cn