User Manual

5.6.2 Auxiliary Port Voltage Calibration

The voltage detected by auxiliary port can be calibrated by drag the slide bar, which is the

same as the Auxiliary Port Voltage Calibration in the On-Screen-Display Conﬁguration

Menu described in section 3.3.3. This can be performed anytime by observing the

measured voltage at the bottom of the Auxiliary Port Option Card.

5.6.3 RSSI Signal Voltage Range Setting

The Full and Low Signal Voltage Settings for RSSI reading can be set here. It is the same

as the RSSI Signal Voltage Settings in the On-Screen-Display Conﬁguration Menu as

described in section 3.3.4 and 3.3.5. Please note that this only can be performed when the

Auxiliary Port is set to “RSSI” Mode as per Figure 5.16.

5.6.4 Video Battery Low Voltage Warning Setting

This option sets the Low Voltage Warning of the video battery when the Auxiliary Port is

set to “Video” Mode. It acts the same function as the Video Battery Low Voltage Warning

Setting in the On-Screen-Display Conﬁguration Menu as described in section 3.3.6. Please

note that this only can be performed when the Auxiliary Port is set to “Video” Mode as per

Figure 5.15.

AEO TECHNOLOGY www.aeorc.cn