User Manual

5.5.4 Timer Trigger Options

This option sets the trigger criteria of the timer on the top-left corner of the OSD in the On-

Screen-Display In-Flight Interface Screen as described in the section 2.2.1. It can be

selected between the “Power-On Start”, which the timer will be started when the OSD is

powered up, and the “Take-Off Start”, which the timer will be started when take-off of the

plane is detected by the system. This setting is not available in the On-Screen-Display

Conﬁguration Menu.

5.5.5 Home Distance Mode Setting

The home distance display mode can be set here, which is the same as described in the

section 3.1.3. The “Line of Sight” mode (the true distance with altitude considered) and

“Ground” mode (the ground distance with altitude factor ignored) can be chosen.

5.5.6 Unit Setting

This setting is the same as the On-Screen-Display Conﬁguration Menu described in

section 3.1.1, which the unit of displayed data can be selected between metric and

imperial.

5.5.7 GPS Time Zone Setting

The GPS Time Zone can be selected from -12 to +12 in the drop down menu. This setting

is exactly the same as the section 3.1.2 in the On-Screen-Display Conﬁguration Menu.

5.5.8 Power Battery Sensor Calibration

You may calibrate the current and voltage sensor by drag the slide-bars in this section. It

acts the same function as chapter 3.2.2 in the On-Screen-Display Conﬁguration Menu.

5.5.9 Flight Recorder On/ Off Switch

The ﬂight data recording can be enabled and disabled by checking the setting option box.

It is the same function as section 3.4.1 in the On-Screen-Display Conﬁguration Menu.

5.6 Auxiliary Port Option

Other than the general settings performed above, the setting associated with auxiliary

voltage detection port can be performed in the Auxiliary Port Option Card beside the

AEO TECHNOLOGY www.aeorc.cn