User Manual

3, On-Screen-Display Conﬁguration Menu

The OSD system must be conﬁgured before taking-off the plane. Most of the system

conﬁguration setting could be performed in the On-Screen-Display conﬁguration menu via

infrared remote controller. Before starting the conﬁguration, please make sure the infrared

beam from infrared remote controller is able to reach the hemispherical!shaped window on

the! infrared sensor module. Therefore, choose the infrared sensor module installation

location on the plane carefully. It is recommended to install it under the transparent cockpit

cover.

Once the OSD system is powered up, and the infrared sensor module is connected, press

the “Menu” button in blue color on the infrared remote controller to switch the OSD display

from in-ﬂight interface screen to the conﬁguration menu screen as per shown in Figure 3.1.

You may use the arrow buttons to operate the menu: press the “up” or “down” arrow

buttons to move the cursor up or down; press the “left” or “right” arrow buttons to decrease

or increase the option item value. Press the “Enter” key in green or the “Back” button on

the lower-left to enter the sub-menu or exit from the sub-menu to the main-menu. And

press the “Exit” button on the upper-right to quit the OSD conﬁguration menu to the normal

OSD operation anytime.

3.1 General Settings

3.1.1 Unit Setting

The unit mode in the system can be selected between metric unit and imperial unit. If

metric unit mode is chosen, it will be the unit of °C for temperature, kilo-meter for altitude

and distance, kilo-meter per hour for speed and meter per second for climb rate. If the

imperial unit mode is set, it will be the unit of °F for temperature, mile for altitude and

distance, mile per hour for speed and feet per second for climb rate.

3.1.2 GPS Time Zone Setting

Select the time zone according to the region you are using the Apache OSD system, so

that the correct time and date are displayed.

AEO TECHNOLOGY www.aeorc.cn