User Manual

FACTS
Why does IGGY turn OFF when I switch to a turn on condion via
my transmier? IGGY is designed to switch on from a pulse width
greater that 50%. Reverse the switch condion on your transmit-
ter will set it right.
Can I use IGGY as a General Purpose Opcally Isolated switch i.e
not as an ignion switch? Yes you can, IGGY can be used for any
general purpose funcon as long as the maximum recommended
voltage (60V) and current draw (4A or 6A) is observed.
Current carrying capacity of connectors - IGGY will handle up to
4A current on the baery/ignion circuit so a JR type connector
is more than adequate for most uses. If a higher current rang is
required we also oer IGGY in a 6A version with Ultra connectors.
Current capacity will then be limited to IGGY design.
Using IGGY with a voltage regulator - IGGY was designed to work
with all current RC products regulated and unregulated. If you
prefer using LifeP04 chemistry baeries (nominal 6.4v) then IGGY
will work excellently in most RC Ignion applicaons without a
regulator.
If you prefer to use newer higher 7.2 volt servos then we rec-
ommend using IGGY with Lion (nominal 8.2v) or Lipo baeries
(nominal 8.4v). These baeries will in most cases require a voltage
regulator.
9