User Manual

Turning IGGY ON

Aer connecng IGGY (as shown on page 4) turn on the model’s

receiver, IGGY will start to ash slowly. This is an indicaon that

receiver power is being supplied to IGGY.

While the Blue LED is ashing.

PRESS the Yellow “ON/OFF” buon. IGGY’s blue LED will start

to ash faster indicang that IGGY is ready to arm the ignion

circuit. Now, if you have adjusted your receiver channel correctly,

switching on the selected transmier switch/channel will arm

IGGY (Ignion state is on) and the LED will be permanently lit. If

the blue LED does not light up permanently then you will need to

adjust your transmier. Please refer to your transmier instruc-

on manual.

HINT use a sck channel (moving the sck up down or le right)

to verify IGGY’s arming funcon (Blue LED permanently On) and

then once sased all is well move IGGY to a switch channel on

your models receiver.

OFF

Booma RC

IGNITION