User Manual

5
PLEASE NOTE: One of the safety features is that IGGY draws it’s
power from your models’ receiver so IGGY is completely inoper-
able unless connected to your model’s receiver and the receiver
is powered up!
Iggy also requires one receiver channel to operate and is set to
switch at approximately 50% of sck posion. It is recommended
to connect Iggy to a switch channel on your receiver and adjust
the switch unl IGGY operates as required. Seng up a transmit-
ter for switching will dier for each transmier type so please
refer to your transmier manual for switch channel seng.
FOR THE TECHNICALLY MINDED ONLY
IGGY has a dead-band where neither an On or O state is acve.
This funconality is built into Iggy so that Switch uer cannot
happen.
Also a bad signal (no pulse or less than 50% mark space rao)
must be present for more than 20 connuous frames before Iggy
will kill the ignion. In most modern receivers fail safe is built
in so this condion should never be met except as a complete
system safety feature.
This dead band feature comes at a cost of a small delay (approxi-
mately 500 - 600 milliseconds) in switching ON/OFF.
PLEASE NOTE
Please observe correct connecon polarity i.e. RED is baery
posive and BLACK is baery negave.
An Incorrect polarity connecng will not allow your baery to
supply power to the Ignion.