User Manual

Mode 8: Remote control cascade trigger mode
Under this working mode, we strongly recommend an independent battery for modules of GENERAL USE GLOW
PLUG DRIVER, not sharing a battery with receiver. The connection diagram is the following: all the remote control ca-
bles of GENERAL USE GLOW PLUG DRIVER modules are connected in parallel, only earthed cable and signal cable
are connected with receiver, you don’t need trigger button under this working mode, ( the trigger button only can be used
as indicator light, it would lead to function disorder if the trigger button were pressed). The driver group is controlled by
a corresponded three-gear switch on the transmitter, when the three-gear switch is pulled to mid gear, all of the drivers
will be on half power output (stable output), when the three-gear switch is pulled to up gear, all the drivers in the group
will be on full power output.
MODE 8