User Manual

MODE 7: long press trigger button cascade working mode
Connection diagram is as the following, only through one trigger button, 1 to N pieces of GENERAL USE GLOW
PLUG DRIVER module can work together at the same time. Under this working mode, only module 1 needs to connect
the trigger button, all the other modules don’t need a trigger button but parallel connected all the remote control cables.
The working mode is very similar with working mode 6, the only difference is the long press (more than 2 seconds), the
indicator LED flashes, after 5 seconds’ time lag, all the modules will be on full power output for 30 seconds, then enters
half power output automatically for 15 minutes, after that, it enters standby automatically which is similar with working
mode 2.
MODE 7