User Manual

Mode 5: Remote control constant working mode
Under this mode, you need to short connect signal wire B and R to the trigger button, when you pull the three-gear
switch (corresponds to the channel on transmitter) to mid gear, GENERAL USE GLOW PLUG DRIVER will be on half
power output, pull the switch to up gear, GENERAL USE GLOW PLUG DRIVER will be on full power output which
will be no limitation from 30 seconds or 5 minutes protection, user should pay attention to the risk of running down the
battery, especially when it is sharing a battery with receiver. The trigger button is only used as a indicator light under the
mode.
MODE 5