User Manual

4) 10 kinds of working mode
Mode 1, manual trigger:
Connection diagram as the following, short press the trigger button, indicator light flashes slowly (on 0.5 second, off
0.5 second), after 5 seconds’ time lag, output 30 seconds in full power, glow plug turned red hot state which is suit-
able for starting up engine, then power is turned off automatically and enters standby.
MODE 1
Mode 2, Manual long press:
Connection diagram as the following: This mode is very similar with the first working mode but stable working
mode was added, long press the trigger button, indicator light will be constant on (on 1 second, off 0.5 second), after 5
seconds’ time lag, output in full power for 30 seconds, under this state, the glow plug is hot red which is very suitable for
starting the engine up. After the 30 seconds’ full power output, it will enter half power state automatically which we
called stable working mode, and the power will be turned off after 15 minutes’ stable working mode, it enters standby
state. The glow plug is only driven to slight hot red under the state of stable working mode, so it can keep the tempera-
ture inside the engine constant, and the engine RPM is stabilized, power consumption is very low too, it can also increase
the life of glow plug.
Mode 2