User Manual

Appearance of GENERAL USE GLOW PLUG DRIVER
There are 2 LED lights on GENERAL USE GLOW PLUG DRIVER in total, one LED light is on PCB, and the other is
on its button.
1) Introduction for ports
There are three ports in total on the PCB of GENERAL USE GLOW PLUG DRIVER. Port 1 is for control button; Port
2 is for power supply and remote control; Port 3 is for glow plug driver.
It gets a DC-DC system of high efficiency internal controlled by MCU, it can figure out the remote control signal from
the receiver, checking and feeding back the working status of glow plug timely.
There is a screw hole for mounting on the top right corner, through which customer can mount GENERAL USE GLOW
PLUG DRIVER on the aircraft model.
2) Trigger button