User Manual

Misc. Settings 2
Various settings – First option listed is the default
• Board Offset (see Appendix H)
o 0 – Zero degrees offset. KK2.1.X board faces forward.
o +45 – KK2.1.X board is mounted 45 degrees clockwise (top left corner points in
direction of flight).
o -45 – KK2.1.X board is mounted 45 degrees anticlockwise (top right corner points in
direction of flight).
• Spin on Arm
o No – When armed, with throttle at zero, motors are stopped.
o Yes – When armed and throttle is at zero, motors run at the speed set by Minimum
Throttle. This is useful if you want to fly and never want your motors to stop in flips
and rolls for example.
• SS Gimbal
o No – A normal camera gimbal is being used with one servo for Pitch and one for Roll.
o Yes – Super Simple Gimbal is used where both servos work together to move Pitch
and Roll in a differential configuration.
• Gimbal Control
o No – Gimbal offset is fixed as set in Camera Stab Settings.
o Aux – Gimbal Pitch offset can be changed using the Aux channel (see Appendix B).
This enables you to change the Pitch offset with a Standard PPM receiver.
o 6&7 – Gimbal Pitch and Roll offset can be changed using the receiver Channel 6 and
7 outputs. Note that you will need to use this feature with a CPPM receiver, satellite
receiver or SBus receiver.
• Alt Safe Screen
o No – Standard SAFE screen layout
o Yes – Alternative SAFE screen layout which displays the last Motor Layout selected
(this is just a guide as you may have changed the settings in the Mixer Editor).
• Batt Volt Trim
o Enables you to adjust the battery voltage reading by 0.1 volt increments if you are
not satisfied with the value shown with the default trim value of 0. The range is +/-
0.6 volts.