User Manual

Mode Settings
Various settings – First option listed is the default
• Self-Level
o Aux – AUX channel controls the self-levelling function.
o Stick – Turn on Self-levelling by holding the aileron to the right when arming or
disarming. Turn it off with left aileron. Note, if you only connect a 4 channel
receiver to the KK2.1.X with Roll, Pitch, Throttle and Yaw then set Self-Level to Stick.
• Link Roll Pitch
o Yes – Changes to the PI Settings for both Roll and Pitch when you make changes.
o No – You need to update the Roll and Pitch PI Settings separately.
• Auto Disarm
o Yes – will automatically disarm after 20 seconds when armed and throttle is set to
zero. Note, if Lost Model Alarm is set to “Yes” then you can’t switch Auto Disarm
Off.
o No – No Auto Disarm and no Lost Model Alarm.
• Receiver (if you change the receiver, you need to power cycle the KK2.1.X)
o Std – Standard PPM receiver with 4 or 5 (inc Aux) connections to the KK2.1.X inputs.
o CPPM – Combined PPM receiver connection. This is all receiver channels
combined/multiplexed onto one cable that should be connected to input 1 (top
input).
o DSM2 – A DSM2 satellite receiver (not a main DSM2 receiver) connected to input 3
(middle input) via a level changing cable. Note that the receiver needs to be bound
to the KK2.1.X, not a normal receiver. To bind the DSM2 satellite, hold buttons 2&3
down on power up. The satellite will flash rapidly and you should follow your
transmitter/receiver binding process. Beware that some receivers bind and set the
channels to a failsafe position. You may need to rebind after you set the correct
directions using the Receiver Test menu.
o DSMX – A DSMX satellite receiver (not a main DSMX receiver) connected to input 3
(middle input) via a level changing cable. Note that the receiver needs to be bound
to the KK2.1.X, not a normal receiver. To bind the DSMX satellite, hold button 3
down on power up. The satellite will flash rapidly and you should follow your
transmitter/receiver binding process. Beware that some receivers bind and set the
channels to a failsafe position. You may need to rebind after you set the correct
directions using the Receiver Test menu.
o SBus – An SBus receiver connected to input 3 (middle input) via an inverter cable.
• Channel Map
o No – With a standard receiver, it is generally assumed that you will not map any
channels.
o Yes – Swap channel order using Receiver Channel Map.
• Lost Model Alarm
o Yes – When the KK2.1.X Auto Disarms, it will sound the buzzer. Note that Auto
Disarm is forced on when “Yes” is selected.
o No – Lost Model Alarm disabled. Set to “No” to allow you to set Auto Disarm to
“No”.