User Manual

On the Safe screen, you will see PI1 or PI2 in the top right corner. If you want to use Profile 2's SS &
PI but don't want Self Level, set Profile 2's self level P gain to zero. When this is done, you will see
that Self Level is always Off on the Safe screen.
When switching between the two, be very careful if you are changing Stick Scaling. Best to do this
with sticks at neutral.
Note 7 (Channel Map)
This option allows you to swap the order of the inputs for a standard receiver. Say the Roll input
appears faulty (input 1).
Set the Receiver Channel Map to 5,2,3,4,1 to swap Roll and Aux inputs. Connect your rx roll output
to KK2.1 Aux input to use that for the roll input.
Note, if you are using Sat-CPPM, you need to use the Receiver Channel Map (previously "Sat-CPPM
Channels").
You still need to use input 1 for CPPM and input 3 for satellites.