User Manual

V1.16S1Pro changes since V1.15S1Pro for KK2.1.X
a) Bug fix that prevented Orange R100's going into bind mode (was only in V1.15S1Pro).
b) Select receiver type in Mode Settings. Options are Std, CPPM, DSM2, DSMX, SBus. Note, if you
change the receiver type, you will need to power cycle the KK2.1.X
Also note that if Profile 1 and Profile 2 have different receiver types, you will need to power cycle
when changing between the two.
c) SBus support tested with Orange R710 (thanks to JustPlanesChris for the receiver). Note that you
will need an SBus inverter cable. SBus uses throttle input.
Futaba receivers and Orange receivers also have a different channel order (as always) so you need to
set that correctly in Rx Channel Map.
It may also be necessary to map some channels in your transmitter.
d) Orange R110X satellite now binds (thanks to MikeF74 for the receiver).
e) If you have a tx or satellite that can only work as DSM2, binding is achieved by holding buttons
2&3 on power up.
If you have a tx and satellite that can work as DSMX, binding is achieved by holding button 3 on
power up.
The firmware only supports 1 frame of data. To check it is set as one frame, look at debug and make
sure the numbers don't keep swapping on Satellite buffer.
DSM2 setting needs to be DSM2 1024 / 22ms. DSMX settings should be DSMX 2048 / 22ms. My DX8
only says DSMX 22ms.
f) No longer able to adjust servos when on Safe screen (for safety reasons) but servos still work when
armed and throttle at zero.
g) More efficient Satellite code which has freed up some memory and executes quicker so I've got
more time and space for more features :-)