User Manual

Sensored/Sensorless
ESC's
indicatino LED
Function
Indicatinq LED LED
Status
Low voltaqe
of the
batterv Red LED
Blin kino
Over-heat
of the ESC
and
motor
(95'C)
Orange LED Blinking
Sensored motor
Red
and Oranqe LED
ON
Sensorless motor
Oranoe LED ON
Throttle
Range
Calibration
(
For
first
time using
the transmitter
or changing
the
transmitter
you
must
set throttle
Range calibration)
1-
sw;tch oÍf the ESc,
then connect
ESc with
the battery
packs
and turn on
the transmitter;
set
the
direction
of the throttle
channel to
REV; set the
EPA/Ary value
of the throttle
channel to
I0Oo/o.
2. Hold
the set
button and swÍtch
on the ESc,
wait for
about 4 seconds
untjl the
orange LED is
on solid/ then
release
the Set button,
pull
the throttle
trigger
to
full
throttle
until Red LED
blinks
and will be
On Solid,
the motor
beeps.
3. Push
the throttle
trigger
to Full Brake
untjl the
orange LED
blinks and will
be on solid,
the
motor beeps.
4.
Now return
the throttle
trigger to
the Neutral
position,
both of the Red LED
and
orange LED
blink
simultaneity
and will
be on solid, the
motor
beeps
,
both
of
Red
LED and
orange LED
wink,
the Throttle
Range
Calibration is confirmed.
5. Turn
off the ESC
power
switch.
6. Turn the
ESC back
ON;
you
are now ready
to use
the ESC.
-3-