User Manual

Binding process
1. Insert the binding loop to the channel BIND / CH3 port of the receiver.
2. Connect the receiver battery to BAT pins of the receiver, LED is flashing and this means the
receiver is in binding status.
4. Press and hold the binding button on the rear of transmitter, and then switch on the power
supply.
5. Observe the LED on the receiver, if the LED stops flashing and remains on, this means successful
bind. (This process will take about 5 seconds).
6. Release the bind button on the transmitter, and take out the binding loop.
7. Install a servo and then test.
8. If the tests fail, please repeat the action above.
9. If the tests success, then install the receiver in your RC model, connect the battery (max 6VDC)
and servos.