Manualshelf

User Manual

ManualsBrandsHobbyKing ManualsAircraftHobbyking™ Edge 32bit Acro Naze32 BRUSH Brushed Micro Flight Control Board
123
3. PPM receiver welded to the PPM + 5V, GND .Then set Receiver mode to RX_PPM in
Cleanflight configurator.
Notice:
Before applying power, pay attention to the battery voltage selection.
The default setting is 1S (4.2V); if you use 2s lipo, please first need to disconnect pin2 and
pin 3 and then solder pin 1 and pin2. Prohibit the same three pads shorted together.