User Manual

This small monitor detector is set by plugging in the balance lead, observing the –ve polarity 9 pin

end. At the opposite end there is a tiny micro switch located between the two buzzer alarms.

On plugging in it tells you the ‘ALL’ voltage and then runs through each cell individually showing their

volts. On reaching a cell below the set or pre-set voltage the alarm sounds, so it looks like this is a

great individual cell monitor not an average one.

To select the alarm voltage you want (2.7-3.9 v in 0.1 increments) press the micro switch for each

increment, then after 3.9 volts it can be set to ‘OFF’.

It looks like it retains the last cut-off voltage set so that’s great too.

PAGE 1
This small monitor detector is set by plugging in the balance lead, observing the –ve polarity 9 pin end. At the opposite end there is a tiny micro switch located between the two buzzer alarms. On plugging in it tells you the ‘ALL’ voltage and then runs through each cell individually showing their volts. On reaching a cell below the set or pre-set voltage the alarm sounds, so it looks like this is a great individual cell monitor not an average one. To select the alarm voltage you want (2.7-3.9 v in 0.