User Manual

-
Specificaon
BLUETOOTH ALTIMETER
(
FD-BT
)
MANUAL
Connect the JST of FD-BT to the balance channel
of receiver and connect 1.25mm JST of Bluetooth
with almeter.
There is one 3 secon toggle switch, its funcon
as follows:
Record data: when you make the switch to
“RECORD” Bluetooth module were not access,
almeter gets into working mode and start to
record data, at this me the Bluetooth module
power consumpon is almost 0 mA.
Stop working: When you make the switch to
“STOP” posion, Bluetooth module and almeter
are not working.
Seng clear: When you make the switch to “SETUP” posion, Bluetooth module was access, at
this me the blue LED on Bluetooth will be flash.
Download the newest soware of Android from www.fd-rc.com, and install it to your Android
system. At present, it support Android2.2 version or over. The system will in the installaon of a
new root directory called "FlyDream" folder, the upload data and screenshot of FD-BT will keep
all in it.
Take ZTE U880 for example to show the operaon
Find the soware of FD-Almeter, open it and you will see two icons. The above is connect the
Bluetooth module sengs almeter interface, and the below one is drawing interface. Press the
menu buon of mobile, you can see “Contact us”,” soware state” and “Exit” informaon.
1.
2.
1.
2.
Hardware operaon
The soware of Android installaon
Dimension：28mm*16mm*5mm
Weight：3.3g
Maximum range：10m
Working current：<20mA
Working voltage：3.7V-8.4V