User Manual

HMDVR – Produkt ID:571000086-0 additional informations
The connector GND, K1, K2, K2 is for a.e. inflight controlling your HMDVR. This can be
done by some RX-switch or also by some DIY controller like arduino or anything else.
The connector shown in image above, can be used for switching in the same way as the
buttons K1, K2 and K2.
K1, K2 or K2 have to be connected temporarily to GND. Only K1 or K2 or K3 may be
connected at one time.
The Plug for 5V,GND, Video-in, Audio-in, Video-out, Video-out, Audio-out is an Mini SH
1.25 6-pin JST.
The Plug for GND, K1, K2, K3 is different. It´s an Mini SH 1.0 4-pin JST.
Have success – EVIL PUSHER
This is just, what I found out.
If you use this information, YOU DO ANYTHING AT YOUR OWN RISK.