manual

Manual of QUIK Series Sensorless Brushless Motor Speed Controller
4
Note: 1. 1 long “beeb-----” = 5 short “beeb-”. For example, in “Li-xx Cells Number” setting, 1 long “beeb-----” plus 1 short
“beeb-” ( 5+1=6 ), means a 6 cells Li-xx battery pack..
2.The boldface in above form is the default value.
3. Low voltage Protection threshold (Cutoff voltage) = Li-xx Cells Number * Cutoff threshold. Cutoff threshold is Protection
threshold for one cell Li-xx. For example: if Li-xx Cells Number is 3 and Cutoff threshold is 3.1V, the cutoff voltage will
be: 3.1V*3=9.3V.
4. In step 2, after 3 long tone (The item #11) if release the “SET” KEY within 2 seconds, you will exit program. But if you
don’t change other item value, the ESC will restore all items to default value, and makes two “beep-” sounds.
Throttle Diagram
Top Point of Forward
Forward Zone
Neutral Zone
Neutral Point
Backward and Brake Zone
Top Point of Backward
Top Point of Forward
Top Point of Backward
Forward Zone
Backward and Brake Zone
Neutral Zone
Neutral Point
Wiring Diagram
FAN
RECEIVER
KEY
BATTERY
MOTOR
SWITCH
BAT+
BAT-
RED
BLACK
E S C F O R C A R
+5V
R2
>50 ohm
HEAD
Light
R1
>50 ohm
BACK
Light
QUIK SERIES
NOTE: 1.Only QUIK-60A, 80A and 100A can connect car light (refer to wiring diagram). The resistance of R1 and R2 which limit to
current should be greater than 50 ohm, it recommended for 100Ω, 1/2W resistance of the metal mold.
2.The BEC of QUIK-60A, 80A and 100A is Switch mode and can support 3A continuous current. In order to reduce the
interference, it is necessary to keep ESC far away from the receiver and antenna.
Using LED program card (Refer to the Manual of LED Program Card)