User Manual

33 . Glue 1 pc bended fiberglass and 1 pc original servo arms together.(for aileron)
35. Insert the aileron control horns into the
pre-reserved slots on the aileron and
apply some C/A to fix
it.
36. Push rod assembly: Put the longer
end
of the "Z" bend into the shrink tube
and then overlap one end
of the carbon
firber
rod as shown in the picture, then use
a heat gun to shrink the tube.
(For aileron)
37 . Install aileron carbon fiber rods.
39. Link the servos and elevator control horns with threads. Make sure the threads are
taut and the two ends of the servo arms are tied with threads.
40. Cut a 40mm long carbon fiber strip and a 20mm slot on the bottom vertical fuselage
as shown. Insert the strip into the slot, then apply some C/A to fix
it. The strip is used as a
tail skid ..
- 5-
34 . Glue together the contron horns and
their backplates . (for aileron)
38. Link the servos and rudder control
horns with threads. Make sure the threads
are taut and the two ends
of the servo
arms are tied with threads.
41 . Install the motor.